Week 7- Make the PCB

Step to etching pcb

Step 1: Design

Step 2: Print out the design onto the shiny side of the transfer paper

Step 3: Sand the copper plate so there is a rough surface for the design to stick to when transferred

Step 4: Wash the copper with some water and rubbing alcohol and let it dry

Step 5: Cut out the designs and place them face down on the copper

Step 6: Run the copper plate with the design face down through a laminator 5-7 times until the plate is hot

Step 7: After running the plate through a laminator or iron place the plate into a cold bath and agitate until the paper floats off

Step 8: Place the PCB into the etching solution and agitate for 25-30 minutes or until all the copper has dissolved around the design

Step 9: Once all the copper is gone rinse it in the water bath, let it dry and use rubbing alcohol to whip off the ink transferred onto the PCB

Step 10: And now you have an etched PCB board but you still need to drill the holes

WEEK 6 - Test the component

First step of constructing the sensor Interface with arduino is to construct the overall look of the interface.

Overall look :

After completing the look of the sensor, the source code need to be added in order for the interface to work. The source has the code needed for the interface to interact with the arduino and sensor.

week 5 Find The Electronic Components and Build Code

1) Find the electronic Component

This week I went to the Jalan Pasar to buy some of the components, Hopefully, the components that I buy at Jalan Pasar will be function when it be to assemble together. 

2) build code

 This week I build code and burn hex code into arduino Mega